1. The quantitative feeder is shipped from the factory with all rollers and gearboxes pre-filled with oil, so no additional oiling is required operation. However, before starting, it is still necessary to check whether the oil drain screws and oil injection holes are intact,

 and whether the gearbox has lost oil due to damage during.

2. In normal environments, the bearings of all rotating shafts should be inspected and lubricated every three months. In harsh environmental conditions, the inspection interval should be shortened.3. Add lithium-based grease (molybdenum disulfide or AL-

3 lithium-based grease) to the bearings of the drive roller, driven roller, idler roller, and belter roller. quantitative feeder

4. Inspect the working condition of all components of the quantitative feeder every shift, and any abnormalities must be eliminated promptly. After each year of use, thoroughly clean bearings and gearboxes, and add new lubricating oil and grease.

quantitative feeder